Hydraulic Dampers

dampers-molla-a-gas-mobili-vapsint

The hydraulic damper is made up of a steel cylinder (“body”) inside which a ground, chrome plated (“rod”) slides, reaching theoutside through an oil sealing guide.
End-fittings are applied to the body and rod ends so that they can be fixed.

The elements that identify a hydraulic spring are:

  • body diameter;
  • rod diameter;
  • working stroke;
  • end fittings;
  • length of the fully opened spring (LTA), measured from the centre of the body endfitting to the centre of the rod end-fitting;
  • degree of braking.

The purpose of installing hydraulic springs on cabinets with downwards opening doors is to slow down the door’s movement. Unlike a gas spring, exercising a pushing action, a damper exercises a  braking action during its extension phase, i.e. during door opening, and is on a free run during its compression phase (door closing).

dampers-molla-a-gas-mobili-vapsint-2

The hydraulic spring must be installed with the rod turned downwards (rod’s end-fitting on the door), in order not to loose braking efficacy.

To avoid loosing out on hydraulic spring efficiency (and prevent oil from leaking out) follow these instructions:

  • Avoid any traction being exercised on the door during opening in order not to force the rod exit speed;
  • Do not place heavy objects or other heavy items on the door while it is open; should this be necessary, supply the door it with a stop mechanism (chain or bar);
  • Do not clean the hydraulic spring with abrasive detergents or other abrasive products;
  • Do not hit the spring with blunt instruments.
Vapsint